In both Streamline and Graphics Analyzer, when connecting to an Android device, the target device would briefly appear in the devices list, but then disappear, showing "No targets have been detected" (Streamline) / "Unable to validate ADB" (GA), and reappear after a few seconds - the cycle repeats, as if I have a loose connection.
In very rare occasions, the app was able to get through the "flashing" phase and show me the app to capture, and if I start capture then, the app works just fine afterwards, with constant output and no disconnections. However, it's nowhere near reliable.
I've tried different USB ports, cables and even target devices, but all of them exhibit the same behaviour. Also note that my ADB setup is fine all this time, as I can "adb shell" to my device and it stays connected.
Product: DS 2021.0 Gold Evaluation, with Streamline 7.6 / Graphics Analyzer 5.8
OS: Windows 10 64-bit
Hi Andy, Thanks for the log. There's nothing particularly wrong in the log you sent, but it does look like it is doing eveything twice, which is unexpected. There were some changes in the package scanning and device enumeration in the very latest version of Streamline (version 7.7) which is available in Mobile Studio 2021.1 and will be released in the next version of Arm DS as well. Can you please give MS Starter Edition a quick try and see if you see the same results in the latest edition or not.
Hi Ben, same thing with MS. My DS trial license is expiring soon so I'll have to use MS to try out future advice from here on out.