Arm Development Studio forum DS-5 connect fail when cortex-r5 is in lock-step mode

State Accepted Answer
+1 person also asked this people also asked this
Locked Locked
Replies 10 replies
Subscribers 122 subscribers
Views 16288 views
Users 0 members are here

Options

Related

How was your experience today?

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

DS-5 connect fail when cortex-r5 is in lock-step mode

Jeffrey_lin over 4 years ago

Dear All,

I am using DS-5 to debug Zynq UltraScale+ MPSoC.

Evevrything goes well, but when the Cortex-r5 is run in lock-step mode, DS-5 cannot be connected(Cannot connect to A53 or R5).

When the r5 is in splt mode or r5 is powerd off, DS-5 work well.

Top replies

Stuart Hirons over 4 years ago in reply to Stuart Hirons +1 verified

This is in fact by design and the Xilinx answer record on this issue is at https://www.xilinx.com/support/answers/69183.html This affects any debugger, not just Arm DS! Regards, Stuart

Parents

0 Jeffrey_lin over 4 years ago in reply to Stuart Hirons

Thanks for your effort. Please let me know if any update.
Cancel
Up 0 Down

Cancel

Reply

0 Jeffrey_lin over 4 years ago in reply to Stuart Hirons

Thanks for your effort. Please let me know if any update.
Cancel
Up 0 Down

Cancel

Children

0 Stuart Hirons over 4 years ago in reply to Jeffrey_lin

HI,

I am having difficulty setting the environment up for this, so can you please raise your issue at

https://developer.arm.com/support

and make it clear that is related to this post and I'll pick it up ASAP.

Sorry about this.

Regards,

Stuart
Cancel
Up 0 Down

Cancel
+1 Stuart Hirons over 4 years ago in reply to Stuart Hirons

This is in fact by design and the Xilinx answer record on this issue is at

https://www.xilinx.com/support/answers/69183.html

This affects any debugger, not just Arm DS!

Regards,

Stuart
Cancel
Up +1 Down

Cancel