This is our current setup on a Hardkernel odroid-xu3 board based on EXYNOS5422.
1.- Board is running Ubuntu 14.04.1 LTS. Linux kernel 3.10.59 rebuilt with options:
CONFIG_GENERIC_TRACER
CONFIG_TRACING
CONFIG_CONTEXT_SWITCH_TRACER
CONFIG_PROFILING
CONFIG_HIGH_RES_TIMERS
CONFIG_LOCAL_TIMERS
CONFIG_PERF_EVENTS
CONFIG_HW_PERF_EVENTS
CONFIG_CPU_FREQ
2.- Streamline gatord version 20 (DS-5 v5.20) (built form source)
3.- Gator driver build with MALI support (patch applied as proposed in: http://community.arm.com/thread/6863).
When I capture using the Streamline Data View in Eclipse, I get values in Linux and Mali counters, but for all Cortex-A15 counters I tried, I get no values, just zero.
When I select events using Cortex-A15 counters, like the ones in the picture (Bus: Access, Clock:Cycles, Instruction: Executed, etc.) All this counters
always show zero values in the captured session. Other counters selected from Mali or Linux seen to work well.
By the way, in the Counter Configuration dialog box I can see Cortex-A15, Linux and Mali counters. But I can´t see any Cortex-A7 counter.
In the documentation I can find example pictures (as the one shown below) where A7 and A15 counters are shown together...
Should I see both of them A7 and A15?
In this last picture you can see as Mali counters (marked in green) are showing values when I run some OpenCL code on the GPU,
but counters for Cortex-A15 show no activity at all (marked in red).
Is there any special configuration for my Exynos 5 SoC to make Streamline capture the Cortex-A15 and A-7 counters?
I'm stuck right now, I can't find out what I am doing wrong. Any hint will be of great help.
Thanks!
Thank you Stephen,
<<<Can you confirm that you are building the gator.ko with the following build time options:
<<<GATOR_WITH_MALI_SUPPORT=MALI_MIDGARD DDK_DIR=".../path/to/Mali_DDK_kernel_files"
<<<So in a typical kernel that has Mali integrated you can find your Mali_DDK_kernel_files in drivers/gpu/arm/...
I built my gator using:
make -C ~/.../odroidxu3-3.10.y/ M=`pwd` ARCH=arm CROSS_COMPILE=arm-linux-gnueabihf- -modules GATOR_WITH_MALI_SUPPORT=MALI_MIDGARD MALI_DIR_MIDGARD="~/.../odroidxu3-3.10.y/drivers/gpu/arm/midgard"
So in sw/streamline/gator/README.md, it says:
___To add the corresponding support to Mali___
Userspace (scons) needs gator=1
I am not sure how can I add gator=1 to support mali. Where can I access the userspace?Can you please help?
Thanks a lot.
Hey DynamicProfiling,
The make option should be DDK_DIR not MALI_DIR_MIDGARD so that could be where you are getting some of your issues. The instructions can be found in README.md in the gator source director just scroll down to Mali GPU.
So there are 2 ways that you can build the Mali driver to have gator support. Kernel space or User space. If you want User Space support you will need to contact HardKernel directly as they will have access to the userspace source. Kernelspace support should be available if you just use the options in the README.md.
Alternatively if you are using a driver version greater than R13P0 the gator flag for userspace support should be enabled by default.
Hope this helps,
Stephen