Arm Development Studio forum Setting Static IP Address for DSTREAM

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Setting Static IP Address for DSTREAM

Note: This was originally posted on 20th July 2012 at http://forums.arm.com

Hi guys!

I'm trying to help troubleshoot my customer's target connection to the DSTREAM. Initially I ran rvi_log_client on DOS but the information was not enough, so I've got to use DAPlog and CSAT. For DAPlog, I understand that due to some bug, DAPlog cannot run on USB, so I have to use an Ethernet crossover cable. Being a newbie, I connected it directly to my host computer, and of course it didn't work. The problem lies in setting a static IP address to my DSTREAM.

Already, I've ran 'debug hardware config IP', deselecting DHCP and then entering the network information as per instructions found on ARM's website. http://infocenter.ar...qs/ka3908.html. After configuration and replacing my USB cable with the Ethernet crossover cable, I can't get it to run. Using DHCP is no different - the IP address remains stuck at 127.0.0.2, which I know is wrong. I've also tried the host computer's IP address+1. Same result.

The result are;
1. When I run csat.exe, I can't connect to the DSTREAM through TCP/IP. It could only connect through USB, probably because 127.0.0.2 is not the correct IP address of the DSTREAM.
2. When I tried daplog, I got this message "Failed to connect to the RIFS server".

Any ideas on how to solve these issues? I've been on this for the past 5 days.

Fadil@SG