This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

DS-5 FVP debugger always shows "Failed to load symbols for "Hello World.axf""

I started to use DS-5 recently and applied for a evaluation license for professional version.

I followed instructions strictly from this page DS-5 Documentation & Resources / Tutorials / Getting Started with ARM DS-5 | ARM DS-5 Development Studio

But I got this error message, like this picture shows

This make me can't debug from source-level.  I can't set breakpoint into c file , but i can set breakpoint into disassembly file. Is  there any solutions?

1.jpg
Parents
  • Hi 57hillside, zm290293817,

    It looks like this is definitely a regression in DS-5, we've confirmed that it used to work and only affects DS-5 5.24.0.

    We'll keep everyone updated on this thread as to when a new release of DS-5 contains a fix. Unfortunately any workaround for DS-5 5.24.0 would be non-trivial. If it's possible to use DS-5 5.23.1 then that would be our recommended solution for the time being.

    Ta,

    Matt

Reply
  • Hi 57hillside, zm290293817,

    It looks like this is definitely a regression in DS-5, we've confirmed that it used to work and only affects DS-5 5.24.0.

    We'll keep everyone updated on this thread as to when a new release of DS-5 contains a fix. Unfortunately any workaround for DS-5 5.24.0 would be non-trivial. If it's possible to use DS-5 5.23.1 then that would be our recommended solution for the time being.

    Ta,

    Matt

Children