This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Driving nTRST and nSRST signals through ARM DS-5

Hello All,

              I have connected my target board via a JTAG connector to ARM DStream and using ARM DS-5 to debug it. I would like to know the mapping of nSRST and nTRST reset signals of ARM DS-5 eclipse environment. Does Connect/Disconnect to target drive the nTRST signal and Reset.system drive the nSRST signal through DS-5 ? Please correct my understanding if I am wrong.

Also, I would like to know is there any other method (any command line utility) to drive these signals without ARM DS-5 ? Please help. Thanks in advance.

Parents Reply Children
No data