This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

RCF files

Hi I would like to have more insigth on rcf files: There is a bunch of parameters aka config_item. how thery ere used? and how to get their meaning? I'm specially interested in parameters for CORESIGTH like CORESIGHT_BASE_ADDRESS_MSW

thanks

claude

Parents

+1 Stuart Hirons over 9 years ago in reply to claudio06

Hi,
Ok. For AMP, the connections to the cores are treated separately in DS-5 and the policing of the low-level JTAG/SWD accesses to the DAP/cores is performed by the DSTREAM.

So I guess you would have to see how the other debugger might handle this use-case.

Regards,
Stuart
Cancel
Vote up 0 Vote down

Cancel

Reply

+1 Stuart Hirons over 9 years ago in reply to claudio06

Hi,
Ok. For AMP, the connections to the cores are treated separately in DS-5 and the policing of the low-level JTAG/SWD accesses to the DAP/cores is performed by the DSTREAM.

So I guess you would have to see how the other debugger might handle this use-case.

Regards,
Stuart
Cancel
Vote up 0 Vote down

Cancel

Children

No data