This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ask for helps in instruction:ADR{cond} Rd, label

Note: This was originally posted on 3rd September 2012 at http://forums.arm.com

ADR.W    R1,F4_ROM       ;F4_ROM is the label of the table below
    STR     R1,[R0]
    ..........
F4_ROM
    .short   0x100,0x200
    .short   0x300,0x400

when i use the instruction ADR.W above,the compiler tells : [E0200] Offset out of range.how can i solve the promble? thanks.

Parents

Etienne SOBOLE over 12 years ago

Note: This was originally posted on 4th September 2012 at http://forums.arm.com

hello,webshaker, how can i get the lower16/upper16 of the F4_ROM, F4_ROM is not a constant.by the way,the compiler i use is TI's ccs5.2.

That's right.
But the linker know the value of the address F4_ROM

Just try the code I gave you that should work !
Cancel
Vote up 0 Vote down

Cancel

Reply

Etienne SOBOLE over 12 years ago

Note: This was originally posted on 4th September 2012 at http://forums.arm.com

hello,webshaker, how can i get the lower16/upper16 of the F4_ROM, F4_ROM is not a constant.by the way,the compiler i use is TI's ccs5.2.

That's right.
But the linker know the value of the address F4_ROM

Just try the code I gave you that should work !
Cancel
Vote up 0 Vote down

Cancel

Children

No data