This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

OpenCL profiling for Mali GPU

Hi there :), 

I have a question, I am preforming a study on Mali GPUs, the study is done using OpenCL to execute programs on the GPU side. I am trying to use Streamline tool for profiling.

I have installed Gator version 7.8, and Streamline version is 7.8 as well. But I am not able to get OpenCL annotations at all as depicted in the following figure. I tried to reconfigure the DDK, but I didn't find any options related to openCL, is there a certain guide to follow in order to get the output as in the below image? 

My Hardware platform is Odroid N2+, Linux based with Mali GPU G52. 

In the provided image everything is clearly shown, OpenCL Queues, Threads execution.. etc 

Any Support would be much appreciated. Provided bellow, all Mali flags taken from my Linux Kernel config file.  

 

# CONFIG_DRM_MALI_DISPLAY is not set
CONFIG_MALI_MIDGARD=y
CONFIG_MALI_GATOR_SUPPORT=y
# CONFIG_MALI_MIDGARD_DVFS is not set
# CONFIG_MALI_MIDGARD_ENABLE_TRACE is not set
# CONFIG_MALI_DEVFREQ is not set
# CONFIG_MALI_DMA_FENCE is not set
CONFIG_MALI_PLATFORM_NAME="devicetree"
CONFIG_MALI_EXPERT=y
# CONFIG_MALI_CORESTACK is not set
# CONFIG_MALI_PRFCNT_SET_SECONDARY is not set
# CONFIG_MALI_DEBUG is not set
# CONFIG_MALI_FENCE_DEBUG is not set
# CONFIG_MALI_NO_MALI is not set
CONFIG_MALI_TRACE_TIMELINE=y
# CONFIG_MALI_SYSTEM_TRACE is not set
# CONFIG_MALI_JOB_DUMP is not set
# CONFIG_MALI_2MB_ALLOC is not set
# CONFIG_MALI_PWRSOFT_765 is not set
CONFIG_MALI_KUTF=m
CONFIG_GATOR_WITH_MALI_SUPPORT=y
# CONFIG_GATOR_MALI_4XXMP is not set
CONFIG_GATOR_MALI_MIDGARD=y
CONFIG_GATOR_MALI_MIDGARD_PATH="drivers/gpu/arm/midgard"

Additional hint is that its mentioned in Streamline FAQ Page (https://developer.arm.com/tools-and-software/embedded/legacy-tools/ds-5-development-studio/streamline/streamline-faqs)

that one should build Mali DDK with the following flags using scons. ['cl=1; streamline_annotate=1; instr=1; timeline=cl_timeline; gator=2'.];

1. The DDK does not have the Sconstruct file, so scons command fails.

2. I didn''t find any flags related to OpenCL.

3.  The <process_name>.instr_config  is never generated.

Looking forward for your support.

Thanks.

Kind regards,

Ahmed

Parents Reply Children