This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Connect ST-Link JTAG to Keil IDE

Hi,

I have STM32F107VCT6 board,ST-Link debugger and Keil microvision3 IDE.My chip is not listed in device database.How can I add this device to the list?Is there any document which describes how to setup and debug the STM32MCB with St-Link Jtag thru keil Microvision? I tried sometime to figure out this and could not find any.

Please help me in this

Thanks
Rama

Parents

0 Rama Devi over 16 years ago in reply to Bruno Coppi

Thank you very much. I were able to execute examples in my board using the STLink JTAG :)
Cancel
Vote up 0 Vote down

Cancel

Reply

0 Rama Devi over 16 years ago in reply to Bruno Coppi

Thank you very much. I were able to execute examples in my board using the STLink JTAG :)
Cancel
Vote up 0 Vote down

Cancel

Children

No data