BUG in c51v808a.exe?
When i first connect the ULink the JTAG device ID is found and it is possible to program the device. After programming the device ID cannot been found anymore. Tried it with two units and both do not show up AFTER programming. The third (last) shows up all the time but i don't want to programm it because i don't know what happend.
Programmer: Keil ULink Device: ST upsd3434EV Software NOW: Keil uVision3 (eval c51v808a.exe) NOW Software Prev: Keil uVision3 eval uPSD (ST DK3400 kit)
Does the programmer blow op the device's JTAG interface. (uC is working afterwards, can't see if software is updated)
The hardware worked before because al three devices have been programmed and re-programmed various times. The only difference is: - I got a new PC and installed the newest Keil software to see if there are any changes since hte uPsd version.
NOW the question: Are there other people which have got the same problem?
Made a bug report and will keep you informed and post their reaction below. Bug report: Using ST DK3400 development board. Evaluating both Raisonance and Keil software.
Newest Keil uVision3 (eval c51v808a.exe) with ULINK doesn't reconize uPSD3434EV when lock bit has been set. (RLINK does reconize and can erase)
I have discussed the problem here on your forum.
http://www.keil.com/forum/docs/thread10258.asp
This problem is fixed now. Please see: http://www.keil.com/support/docs/3355.htm for more details.
Hans
As you can see above the bug was found and fixed. The updated ULINK driver indeed fixes the problem and now it works as it should (and worked in the past).