Hi,
I am attempting to communicate with the ADUC7026 via the JTAG connector so that I may program it. I am using the mIDAS-Link interface module for communication but to no avail. However, I am able to communicate with the ADuC7026 Eval Board without a single problem.
When it fails to communicate, it states the following error: Attempting to read 0x01, read 0x07. It also states that my configuration settings might need adjusting.
Has anyone experienced this problem before? Can someone offer some insight into this problem please.
Any help would be greatly appreciated.
Saul
So did you adjust your configuration settings?
Hi Keil,
thank you very much for responding to my query. To be honest with you, this is the first time that I am working with the ADuC7026 let alone the IAR development environment. So, to answer your question, I really wouldn't know which settings to change as the Eval board has the same ADuC7026 that we are using in our design.
Have you experienced this issue before where you connect to the Eval board and it communicates seamlessly but as soon as you attempt to communicate with your ADuC7026 it does not recognize it?
Then why are you asking on the Keil forum??!!
I actually got it to work. What was causing it to not communicate was our ADM708 3V uProcessor supervisory circuit. It's driving pin 69 (BM) low. So it was not the ADUC7026 that was failing, it had to do with our external circuitry.
In any case, thank you very much for your help.
Regards,