This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

PWM output signal coding

Dear all,

I an in need of coding...... Using arm board TMS570LC4357......Coding required for sending output timing singnal after crossing 58 teeth on a 60 teeth trigger wheel.....Two teeth were removed (59th and 60th).....

Need to count the teeth upto 58......after corssing removed teeth the count should restart..... and timing signal should be sent after crossing 58th teeth before reset....

Kindly help me in this coding.....

Thanking you,

SHIVAKUMAR