• State Suggested Answer
  • Locked Locked
  • Replies 2 replies
  • Answers 1 answer
  • Subscribers 18 subscribers
  • Views 1495 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

In LPC1857JBD208 datasheet, it is mentioned that the total SRAM is 136KB but in keil MD5 there is only 96KB of RAM mentioned. Does anybody have opinion on this?

Prayash

Parents
  • 0

    Yes, I have an opinion. :)

    An LPC1857 project defaults to using a scatter file built from the target options dialog. The dialog only supports two on-die RAM areas, which are set to be 32KB at 0x10000000 and 64KB at 0x20000000. Per figure 5 in the LPC18xx user manual, there's another 40KB at 0x10080000, but it's not contiguous with the region starting at 0x10000000. You'll need to write and use your own scatter file to access that memory.     

Reply
  • 0

    Yes, I have an opinion. :)

    An LPC1857 project defaults to using a scatter file built from the target options dialog. The dialog only supports two on-die RAM areas, which are set to be 32KB at 0x10000000 and 64KB at 0x20000000. Per figure 5 in the LPC18xx user manual, there's another 40KB at 0x10080000, but it's not contiguous with the region starting at 0x10000000. You'll need to write and use your own scatter file to access that memory.     

Children
No data