Hi everyone
I am trying to start with my STM32F100RBT6B in the STM32VLDiscovery and programming in Keil uVision IDE, with Cube MX. I upload the CubeMX code for the uVision and finished the code with 0 Errors and 0 Warnings, but when i try to Download the code to flash memory it replies with this:
and then the flash download fail.
i would be very grateful for the one who helps me in here.
PS: Using the internal STLink with the USB cable.
Westonsupermare Pier said:probably not going to be well supported by current tools
ISTR a thread recently about disappearing support for ancient STLinks ... ?
Westonsupermare Pier said:Consider getting a NUCLEO-64 board
+1
DvdZk - Go to the Product Page:
https://www.st.com/en/microcontrollers-microprocessors/stm32f100rb.html
Choose the 'Tools & Software' Tab.
Scroll down to 'Product Evaluation Tools'
It's there!
Andy Neil said:ISTR a thread recently about disappearing support for ancient STLinks ... ?
Found it:
https://community.arm.com/developer/tools-software/tools/f/keil-forum/45556/command-not-supported-during-download-with-keil-mdk-arm-v5-29/162844#162844