Hello,
I'm trying to configure a STM32F400 board so that I can read from the Cortex Debug + ETM using the gpio pins. Is this possible? The pins are so small that it would be difficult if not impossible to read from those pins when the J-Trace is plugged in. Please let me know if you know of any resources that can help me accomplish this.
This: www.segger.com/.../ ?
I have found this type of adaptor useful for adapting that kind of small connector up to 0.1" pitch:
uk.farnell.com/.../2476039
You could use a 2nd one to adapt back down again for a pass-through board ...
Relly helpful for me. I will buy this one www.segger.com/.../ for my connector to 0.1 pitc.