Support forums

Keil forum missing stm32f4xx_hal_exti.h

State Not Answered
Locked Locked
Replies 3 replies
Subscribers 16 subscribers
Views 7072 views
Users 0 members are here

Options

How was your experience today?

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

missing stm32f4xx_hal_exti.h

geos over 4 years ago

Hi,

I created a project with the Keil MDK and then configured and initialized the microcontroller of ST via the STM32CubeMX. I then tried to compile the generated code with Keil MDK. However I get the following error message : .\RTE\Device\STM32F413VGTx\STCubeGenerated\Inc\stm32f4xx_hal_conf.h(236): error: #5: cannot open source input file "stm32f4xx_hal_exti.h": No such file or directory
In the directory C:\Keil_v5\ARM\Pack\Keil\STM32F4xx_DFP\2.13.0\Drivers\STM32F4xx_HAL_Driver\Inc this file is missing.
Does anyone have a solution?
Software used:
uVision v5.27.1.0
Keil::STM32F4xx_DFP v 2.13.0

0 Ronan Synnott over 4 years ago

Hello, I did a simple test, and I find this file in ..\Inc relative to the generated .uvprojc file.
Cancel
Up 0 Down

Cancel
0 geos over 4 years ago in reply to Ronan Synnott

Thanks for the answer,

I can only find the file in the STCubeGenerated. I copied it manually into the Include Path. Then I get the application compiled.

But shouldn't the file also be included in the Keil STM32F4xx_DFP v 2.13.0 package ( C:\Keil_v5\ARM\Pack\Keil\STM32F4xx_DFP\2.13.0\Drivers\STM32F4xx_HAL_Driver\Inc) ?
Cancel
Up 0 Down

Cancel
0 Ronan Synnott over 4 years ago in reply to geos

No, it is generated by the Cube tool, based on how you have configured the target.
Cancel
Up 0 Down

Cancel