Hi guys. I'm almost new to ARM and I'm working with some kind of lpc1768 eval board and uvision keil 5. I've run gpio, uart and pwm but i have problem with USB.
I want to put some data in a USB Mass Storage Flash in .txt file (such as LED1 = on, LED2 = off , etc) and set my board with these datas. after that make a .txt log file from board status and save it in USB flash. I have read lpc1768 user manual USB topics (device,host,otg) but I didn't understand any thing!
could you please help me with these thing?
TypicalEngineer said:I'm almost new to ARM
How do you mean, "almost" ?
Do you have any experience with any other microcontroller(s) ?
Do you have any experience with programming in general ?
Have you looked on the NXP site for examples, application notes, and other support ?
Thank you for your reply.
I'm working on lpc1768 for about a month. I've worked on some AVRs before such as attiny24,13, atmega8,16,32
I'm not an experienced C/C++ programmer but I can handle my projects.
I'v tested NXP's examples, I'v read UserManual, Compaq Open Host Controller Interface Specification for USB document and general review on USB specs and its protocol
View all questions in Arm Development Platforms forum