BUSY transfer and WAIT state both are using the same time ,How to perform the AHB?

Hi sir,

       T1=NON-SEQ

       T2=BUSY

       T3=SEQ

       T4=SEQ

      T5= SEQ

         This is for WRITE operation:

         i am  using a BUSY state for T2. Then my WAIT state for till T3.  I have read from the forum if WAIT state u are using a BUSY transfer, you can change next clock on the  valid transfer.

         If i change the HTRANS to the valid transfer my T1 data will  be maintained for till T3 clock. Then what about the BUSY transfer.

       This same as applicable for READ operation.And this is only for WAIT STATE.

 Regards  

 Rajaraman R