This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Four beat wrapping burst in AMBA AHB lite

  

I was reading the specification and I came across this timing diagram for a four-beat wrapping burst and I am really confused. So during T1-T3, the input address is 0X3C but during the next cycle T3-T4, the input address changed to 0X30. Isn't it supposed to increase by 4 bytes (since HSIZE is word) to become 0X40? Why did it decrease? Also, how is a 16-byte address boundary achieved here? A detailed explanation will be greatly appreciated.

Parents Reply Children
No data