Hi, I am new to Keil software. I am using STM32F4O7 discovery
board. I want to run my code and then get variable values from the
memory window so that I can plot in Matlab. For this, first, I want
to run a few examples which are already present. So I took one
example from module-13 and then build it and then downloaded it onto
the hardware. Then I started the debugging session. Then I ran the
code and stopped it in between. I am not able to see any variables in
the memory window, watch window.
Can I open the file from any location initially or should I save
it some folders? Is this execution flow correct? Is there any good
material for beginners readily available on the internet?
Yes - vast amounts of it!
But, again, this sounds like a school assignment - so your first
point of contact should be your teacher, and your course notes, and
your course reading list.
Specifically for the STM32, ST themselves have a load of
And, again, from Keil:
And some general 'C' learning & reference resources: