• State Accepted Answer
  • +1 person also asked this people also asked this
  • Locked Locked
  • Replies 2 replies
  • Subscribers 20 subscribers
  • Views 1442 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ARM Dual-Timer Module (SP804) Technical Reference Manual

seki.hikaru

ARM Dual-Timer Module (SP804) Technical Reference Manual r1p0 issue D (DDI0271.pdf) has wrong descriptions.

#1 p2-9

Free-running mode
Free-running mode is selected by setting the following bits in the TimerControl
Register:
• set TimerMode bit to 1
• set OneShot bit to 0.

-> TmerMode should be 0 in Free-runnng mode

#2 p2-10

Periodic mode
Periodic mode is selected by setting the following bits in the TimerControl Register:
• set TimerMode bit to 0
• set OneShot bit to 0.

-> TimerMode should be 1 in Periodic mode.

#3 p2-13

Table 2-1 Expressions for calculating timer intervals

Periodic and One-shot : (TIMCLKENXDIV x PRESCALEDIV)/TIMCLKFREQ x TimerXLoad

-> Timer counter is decremented from TimerXLoad value to 0. So, this equation should be

     (TIMCLKENXDIV x PRESCALEDIV)/TIMCLKFREQ x (TimerXLoad+1)

Please fix it.

Best regards.