• Debug Problem
    I am usimg uVision3 V3.72 evaluation V. I am write moduler program for all peripheral in LPC2138, now i just integrate them together, BUT THE PROBLEM is when i start debug it goes into run mode, and...
  • debug Problem
    I want debug the example of EXTMEM on Keil MCB2300 Board,I get the following error: " Data Abort: ARM Instruction at 00000174H, Memory Access at FFE08000H" someone can tell me what is this error. ...
  • Debug problem
    Hi, I am working on a project which uses Cortex-M3 processor and STM32W108CB microcontroller and I use keil uvision4. The problem is the execution of the program stopped before it goes to the main...
  • Problem with Debugging
    Hello. I am writing a simple program for the EZUSB FX2 board, when I compile, I have no errors and no warnings but when I try to debug (my interrupt function is not working) then I get the following...
  • Debug Problem
    what is the reason for the following problem? //*****************************************// Connected to Monitor-51 V3.0 Load "C:\\Test\\LCD_test\\LCD_test" ***error 121: AGDI: cannot access target...