• Interfacing GSM module with STM32F0xx
    I am interfacing a gsm module with stm32f0 board. I am new to this section. I want to send and receive AT command to gsm module and receive its response via UART. Sending section is completed but...
  • LPC1517 SWD Flash Programming Failure
    Hi, Using uvision 4.70 and Ulink2 (fw 2.02) fail to flash LPC1517 with : " Error: flash Download failed - Cortex-M3 " only at those addreses : Programming Done. Contents mismatch at: 0000001CH ...
  • Ulink2 not able to flash TLE9867 device in Keil5.20
    Ulink2 is working fine in Keil4.73 and is able to program TLE9867 device but in Keil5.20 with firmware V2.03 of Ulink2 it is not able to program TLE9879 Infineon MCU. in keil4.73 even with firmware...
  • ULink2 and SWD
    Hello Folks, Is there any way to get the ULINK2 running with SWD? I see on the website a dialog showing how to switch between normal JTAG and SWD? When I go the settings dialog none of these settings...
  • SWD connection
    Hello everyone! I'am in a design phase of my first PCB mounter with an ARM processor, and I'am not sure if i correctly connected the programmers pins to the mcu ports. My processor is: STM32F302RCT6...