• in debug mode, won't enter main()
    Hello, I am looking for some help with my Keil uVision 5.27. I am able to run some example code for my chip that I downloaded from NXP. I have 0 errors and 0 warnings. I am able to go into the debug...
  • code is not entering to main function
    hi sir, i am trying to implement a code on stm32f103 board using keil microvision4 in c.sir the problem i am getting is the code not entering the main().it is getting stuck at one address: 0x08001534...
  • LPC2294 - NOT ENTERING IN MAIN
    HI I AM FACING ONE PROBLEM IN LPC2294 CUSTOM BOARD. I CAN ABLE TO ERASE AND PROGRAM THE DEVICE. BUT IF I TRY TO DEBUG, SOFTWARE CONTROL IS NOT ENTERING IN MAIN FUNCTION. (24 MHZ CRYSTAL, PLL IS DISABLED...
  • Cannot enter debug mode
    Ulink2 was working fine,suddenly when i try to debug giving error message "Cannot acess memory" why is it?What is the solution?
  • Cannot enter Debug Mode
    Hi when downloading i get the error message "Cannot enter Debug Mode" is any one know whats the problem. best regards