• I2C Interrupts
    Hello Guys, I was able to accomplish the I2C Interrupts ; When I created a separate project for I2C Interrupts I was able to read all the data on req addresses but later when I integrated the I2C...
  • I2C interrupts
    This is the example code i used for the simulation in keil. after runs the simulation, the status reg changes to 0x08, but not entering to interrupt service routine. #include <LPC21xx.H> unsigned...
  • I2C interrupt or polling
    Hi, I am using NXP LPC1837 controller as a master and it is supposed to talk to other devices over I2C. The firmware is based on Keil V5. In the firmware code, I2C was initialized without...
  • i2c interrupt not taking in lpc2148
    sending my whole code....... #include <LPC21xx.H> #include"prototype.h" unsigned char word[10] = {"india-pak"}; unsigned char i = 0; int main() { // VPBDIV = 1; PINSEL0 = 0X00000050; VICIntSelect...
  • i2c simulator interrupt problem
    For the STM32F101 uC, the reference manual states that an interrupt is generated on I2C whenever the ADDR bit is set in Master mode, after the uC sends and address and it is acknowledged by the slave...