• Uart, Data not transfer on Hyper Terminal
    Hi, I am using LPC mx-1114/301 board. Small piece of code written to send and receive the data to and from Hyper terminal. Output, not showing typed data on terminal window. Any problem in source...
  • Hello World and hyper terminal
    Hi all, When i run the below program in the simulator ,i can see the output "hello world" getting printed in the serial window and LED blinking in Port0.But when I am running the same program in the...
  • working with Hyper terminal
    Hi I have been trying this code using uVision emulator and it works fine, then I download it to the Infineon C167CR-L and again works fine using Monitor. I stop debugging and connect the serial port...
  • sending numerical values to the hyper terminal
    hi, I am using a 8051 microcontroller in my project. The purpose of the project is to count the pulses using a controller. I have configured 8051 in the counter mode and the counted value is being sent...
  • problem with "local echo" in hyper terminal?
    I am using hypertrm for communicate with gsm modem,my problem is i am not using "local echo",but characters are displayed on hypertrm when i used key board storks,and it was not shows the responses from...