• changing Clock and PLL setting
    Hello.... I was using keil 5 that I installed it last year.This year, after refreshing my windows, I had to install keil 5 again, but this time, I have a problem with new version of system_stm32f4xx...
  • pll and clock setup issue on mcbstm32c
    hey,, >>i want to use usart-2 peripheral on MCBSTM32C and i realised the baud rate set was incorrect, (inspite of right calculations) which was because of the incorrect plck-1 (=112.5Mhz, which should...
  • Cortex M0 crp3 enabled - how to disable?
    CRP3 has been unintentionally activated on a cortex m0 chip. How can i clear crp 3 via something like flash magic?
  • PLL ISSUE
    Hi, I am working on ARM7 LPC2148 board. I want to know on which clock does the LPC2148 runs when I dont initialize PLL ? External oscillator of frequency 11.059 MHz is connected to the board. Could...
  • PLL Configuration
    Hi We are using LPC2366 controller When we configure the Internal RC oscillator(4 MHZ) for the PLL as shown below Main OScillator = disabled PLL source = Internal RC oscillator(4 MHZ ) ...