• Keil failes before debug mode
    I debug some soft on Infineon C166 using Keil. Yesterday the project was completely OK, I compiled, loaded and debugged everything. Today when I try to lauch debug mode it says that "The program uVision4...
  • Keil uVision debug BreakSet on infinite cycle
    There is some questions about testing using function editor tool in keil uvision (debugger mode). There is code which is to be tested: void init_ports(){ if( IDCHIP == 0x2302 && IDMEM == 0x3040...
  • Keil Phytec KC167 Serial Debug Problems
    I'm new to Keil and the Phytec boards, but am trying to debug serial comms through P2 (the one shared with CAN). I know there are conflicts due to interrupt sharing with the monitor, but is there a way...
  • Breakpoints debugging
    Hi everybody. I have a problem. When I start debugging my hardware, I canÂ't put any breakpoint in my software program. Is a wrong configuration problem?. I have tried to write BE * command in output...
  • How to use CCU6 Module in XC164CS Rev200 Board in Keil Debug
    Hi I am using XC164CS Infineon Boards Rev 200. I configured DIP settings for Boards as mentioned in Keil "Monitor for Infineon XC16Board REV 200". I am unable to use CCU6 Pin because these pin's are...