• Simulating an external memory location
    I'm converting from Metalink's metaice for my 87c51 development. I'm having trouble figuring out how to dynamically adjust the external memory locations that I'm using for external port inputs. The port...
  • Can I Simulate External Memory?
    I'm using uVision to test a program I am writing for a project and I was wondering if there was anyway I can put value in some sort of external memory so I can test that my program is reading from those...
  • simulating external memory with out P2 addressing
    I'm trying to simulate a simple design (written in assembler), in uVision4, that has a few memory mapped peripherals and uses P2 for GPIO. In "options for target" I set "Off-chip Ddata memory" to: Start...
  • Simulation of External pulses regarding.
    Hello, In the book " The insiders guide to Philips ARM 7 based microcontrollers" An Engineer's introduction to the LPC 2100 series page no. 141 it is given that "within uVision there is a full scripting...
  • External interrupt 0 Simulation
    Hi there, Iam facing the following problem while trying simulate EINT 0 (w.r.t.LPC2368, Port pin 2.10). If I try to invoke the interrupt in the simulator by pulsing the Port Pin 2.10 in the GPIO Fast...