• Problem with pin port
    Hello I have a problem with my code. I have configured P2_P8 how fast interruption. When I create a button in keil debugger I don't have any problem define button "ppoAvisoAI", "PORT2 |=0x0100...
  • Port pins too slow
    Hi.. I have a problem with the xc167ci. Its I/O-Pins toggle too slowly. If I have e.g. pin 4^0 toggeling, it only works with 2,85 MHz instead of 40 MHz (system clock). I use the following sourcecode...
  • PWM pin simulation
    Can I simulate the output pin of a PWM channel using the Logic Analyzer in KEIL simulator?
  • Seeing a graphically simulated wave on a port pin
    Dear 8051 programmers, Someone told me that the Keil tools provide a way by which you can see a graphically simulated wave of transitions of a port pin, i.e. a sort of "software oscilloscope". Is...
  • C164CI: How to set CAN Pins to Port 8
    I am looking for a way to change the CAN-port-pins from port 4 to port 8 (because of the need of all adress-pins). The Infineon doc talks about register C1PCIR (3 IPC Bits). When I set these bits from...