• Cannot enter debug mode
    Ulink2 was working fine,suddenly when i try to debug giving error message "Cannot acess memory" why is it?What is the solution?
  • Cannot enter Debug Mode
    Hi when downloading i get the error message "Cannot enter Debug Mode" is any one know whats the problem. best regards
  • ITM-DEbugging with NXP LPC1768
    Hi guys, First of all, I'm using a LPC1768 development board in combination with a JLink Debugger which supports ITM-Debugging over printf. I'm using Keil MDK 4.10. Using a direct call of ITM_SendChar...
  • NXP LPC2468 Does not always enter bootload mode
    We have a mature product in production using the NXP LPC2468. We bring the first UART out to an RS-232 driver along with RESET and the pin for the on-chip bootloader. On a PC, an FTDI cable for RS-232...
  • changing Clock and PLL setting
    Hello.... I was using keil 5 that I installed it last year.This year, after refreshing my windows, I had to install keil 5 again, but this time, I have a problem with new version of system_stm32f4xx...