• loading effect
    hey i hav tried connecting the port 2 to a 4bit encoder ht12e i hav masked d data n used only 4bits n sending it to ht12e when check d result i get +5v on pins of port 2 bt when i connect it to encoder...
  • ARM Compiler optimization effects
    Hello, I'm using Keil uVision V5.24.2.0 with ARM Compiler V5.06 update 5 (build 528). Initially, compiler optimization level was set to 1. With this level, I found that the address assigned...
  • unable to use simulator effectively
    hello, I have a project that runs on the target without a problem. I want to run the application without the bootloader on the simulator - so I setup the entry point using the --entry linker directive...
  • Noise effect when Debugging
    Hi, I noticed that when debugging any board with STM32L152(designed with myself or ST Discovery board) using ST-Link V2 in keil, it is very sensitive to noise.If you put a probe on the ground of the...
  • BIASE bit effect on DAC
    I am using Silabs 8051F330. Can anyone tell me the effect of BIASE bit (which enables Internal Bias Generator). I could not figure it out reading the data sheet.