• EPM900 ICP for LPC936 not working
    Hi, I'm using an EPM900 board with a LPC936FA as the bondout chip. So far I have been using it in Emulation mode - running my code through Uvision debugger - but now I want to load my code onto the...
  • MCB900, LPC938, A/D
    I'm using the MCB900 with a P89LPC938 and the LPC900 development tools (demo version). I'm trying to test the A/D. Couple of things: 1. REG938.H doesn't list the A/D interrupt enable bit EADC (IEN2...
  • Problem with LPC938 ADC with EPM900
    Hi. I'm trying to simulate 89LPC938's ADC with EPM900, but somehow it is not working. The code runs, but the ADC doesn't run at all. Some info below: 1. Single channel using channel 7 at Pin 2.0...
  • Problem ICP Programming 89LPC901 using EMP900.
    I've followed the AN10258 appnote on ICP programing, where I've constructed a pin-to-pin adapter for the five required pins for ICP programming. Now at the bottom of Page6 of the appnote, there is a...
  • MCB900, LPC938, A/D
    I'm using the MCB900 with a P89LPC938 and the LPC900 development tools. I'm trying to use the A/D reading data from a sensor. I want to make the range of measurements in order to have more accuracy with...