• RTL code example MCB2103
    Hi, I cannot find any project using Keil RTL using a Keil MCB2103 board, even in RTL or MDK V3.03a. The classical blinky would be fine by me. Is there anyone who can help me? Kind regards...
  • Tying VBAT to ground on the MCB2103 Dev Board
    Is there code preventing the LPC2103 from booting normally when VBAT is shorted to grounded on the MCB2103 development board? The Philips's user's manual for the part says to tie VBAT to ground when the...
  • EINT1 example on MCB2103 and blinky example
    first : For some reason there are NO pullup resistors on the MCB2103 board pin GPIO 0.17 and 0.18 both are open drain outputs. Thats why 2 leds will not blink with the blinky example. If you try...
  • LPC2478 SSP
    The SSP peripheral of my LPC2478 (configured to use SPI frames) is generating a "RNE equals 1" status (Receiver Not Empty - thus, there is data available in the RX FIFO) after some data is placed in...
  • LPC1788 SSP maximum speed
    Hi I have simple question about lpc1788: *. what's the maximum bit rate of LPC1788 SSP? maybe it's duplicated question but I need to be sure because I wanna buy and design new board and SSP...