• The problem with burning 8051 Chip
    Hi friends: I need your help again. Right now I am burning AT89C52 chip. In my code I want port P0 to be high, but every time I always get opposite situation. Few pins of P0 port are randomly low. ...
  • DS89C450 code burning problem.
    Hello Everybody, I have a EPROM programmer at my college. I wanted to burn code in my DS89C450 uC. the programmer had only DS89C420. i checked the datasheet it says that the 2 IC's are pin compatible...
  • Code not burning..
    Hi, i have burned code in Teridian's 71M6541F IC which has 8051 15 core inside using Signum's ADM51 emulator. However, earlier code was working fine and I could see the output on LCD. I set one bit in...
  • Problem in problem burning
    Hello everyone, I have purchased LPC2478 development board from EMBEDDED ARTISTS. I want to know how to program the controller. My basic questions are 1. Which method to be used? (USB/SERIAL...
  • Problem in program burning of LPC2478
    Hello everyone, I have purchased LPC2478 development board from EMBEDDED ARTISTS. I want to know how to program the controller. My basic questions are 1. Which method to be used? (USB/SERIAL...