• Interrupt simulation
    Hi, I'm trying to simulate external Interrupts of the infineon XC888CM microcontroller with Micro-Vision 3.31a. The external Interrupt occurs all the time, without changing the input pins. In real...
  • i2c simulator interrupt problem
    For the STM32F101 uC, the reference manual states that an interrupt is generated on I2C whenever the ADDR bit is set in Master mode, after the uC sends and address and it is acknowledged by the slave...
  • External interrupt 0 Simulation
    Hi there, Iam facing the following problem while trying simulate EINT 0 (w.r.t.LPC2368, Port pin 2.10). If I try to invoke the interrupt in the simulator by pulsing the Port Pin 2.10 in the GPIO Fast...
  • µVision4 - Simulator problem with interruptions ...
    Hi, I try to simulate my application with µVision4 (V4.10) simulator tool. I create a stimuli on a pin (PIO1_5) using fonction editor tool. I see correctly my signal on logic analyser when i...
  • Interrupt works in simulator not in target
    The example project from Keil running Timer0 as interrupt source, works in the simulator but in the target there is never an interrupt generated. Rewriting it, polling the interrupt flag works both in...