• Pre-make facilities?
    Hello, In the uVision2 IDE, it's possible to have post-make facilities. Is there a way to have pre-make facilities too? Rgds, Geert
  • Pre-Make facility
    Hi, Apart from finding a post which says 'this has been discussed before', I haven't found much information on if/how I can run perform a pre-make stage on my uV2.40 project. I want to run a dos...
  • Search Problem
    If I click 'Search' in the bar next to 'Start A Thread' and 'Settings' on the forum, there are check boxes to search the Forum, App Notes, and/or Downloads in addition to the Knowledgebase. Very often...
  • Searching for SC80C451
    I am looking for Phillips discontinued part # SC80C451 68pin PLCC Micro Controller. Any body as idea who has the stock...
  • Parameter Search - Replay
    Just a replay of http://www.keil.com/forum/17710. Summary: The old Keil Chip Parameter search was dropped by Keil but still exists at http://www.keil.com/dd/search_parm.asp as pointed out by Jon...