• Port pins too slow
    Hi.. I have a problem with the xc167ci. Its I/O-Pins toggle too slowly. If I have e.g. pin 4^0 toggeling, it only works with 2,85 MHz instead of 40 MHz (system clock). I use the following sourcecode...
  • CLOCK TOO SLOW AND MUST BE FASTER
    I NEED THE PORCESSOR TO RUN AT 82MHZ BUT THE XTAL IS 13>7242MHZ HOW DO I PROGRAM C TO GET THE CODE FASTER? I LOOK IN UVISION AND CHANGE THE FREQ BUT IT DOESNT MAKE CHANGE IN CODE! HAVE I GOT...
  • DebugIO over DCC too slow!
    How to speed up debug output over DCC with ULink? Character rate is extremly low, aprox. 50 cps.
  • External Flash (via FSMC) too slow
    Hello, I'm working with an STM32 (specifically the STM32F103ZE) with an external NAND Flash memory connected to it. I'm using the memory chip and schematic described in ST's application note AN2784...
  • File System is too slow and makes Watchdog Reset
    Hello I have a problem with the file system. If I write files on a SD card with the LPC2378. If to many Files are on SD Card the File system is busy until the watchdog makes a reset. ...