• Runtime Configuration of MAC Address
    Hi, I'm using RL-NET 6.4, I wanted to change MAC address of my boards dynamically, there is this evidence in documentations. The MAC address is written to the Ethernet controller registers when...
  • Configuration
    Hello! I have eight input pins configuration. It is depend on the value of those inputs pins I have one configuration or another, as you can imagine. The name of those pins are selection 1 selection...
  • LogicAnalyzer Configuration
    Hi, I need to configure the Logic Analyzer to debug a project using the STM32F769I-DISC1 and the ST-Link. I have been working with the ST-Link debugger until now and all seemed to work fine but yesterday...
  • Configure EXT_SDRam.ini
    Hi, I'm using LPC3250. I run the 'blinky' software on the PHYTEC-LPC3250 in the External SDRam mode and it works perfect. The Phytec board has 2 x MT48H16M16LF (SDR) SDRAM and the EXT_SDRAM.ini that...
  • SPI configuration
    He att All In my application use the SPI0 device on LPC2364, I have read that the SSEL0 pin in master config must be at vcc with pull-up is corretc? Is possible use this pin in GPIO or must be at Vcc...