• EPM900 ICP for LPC936 not working
    Hi, I'm using an EPM900 board with a LPC936FA as the bondout chip. So far I have been using it in Emulation mode - running my code through Uvision debugger - but now I want to load my code onto the...
  • ICP programing in LPC938
    how the ICP is used for programing LPC938. what is the procedure for this.
  • EPM900 - ICP - P89LPC9103 - no dedicated pins
    Hi all, I am going to use a P89LPC9103 in a very small product. We cannot afford to have dedicated pins or jumpers because of size constraints. RST/P1.5 , PCL/P0.5 and PDA/P0.4 will have pull-up resistors...
  • Problem ICP Programming 89LPC901 using EMP900.
    I've followed the AN10258 appnote on ICP programing, where I've constructed a pin-to-pin adapter for the five required pins for ICP programming. Now at the bottom of Page6 of the appnote, there is a...
  • STR9 128K Bank1 ICP Programming problem
    I have been trying to boot from bank 1 of an STR9 I have used the following example as a test case http://www.keil.com/support/docs/3347.htm this programs fine on condition it targets a STR9...