• Run in debug mode, but fail after burn into Flash
    I'm using ARM MDK to develop TMS470 applications. Everything works in debug mode with ULINK2. I burn the image into internal flash. But it just can't work. Anyone has exp on such case?
  • SPI Flash burning
    Hi, I have to program external SPI flash (W25X16BV) connected to the LM3S9B90 via the SSI port and using ULINK2. (I should burn about 1,5Mbyte data into the serial flash.) I should make an xxx...
  • cannot load flash description
    hi, i have written a code in keilv5 on laptop and copied it to another pc but the code is not flshload into the target device. i found that software packages used are different but i cant solve the...
  • p89v51rd2 code simukation working but after burning not working
    I am using following program for P89v51rd2. In Keil simulation is working but when i am burning same using Flash Magic ,it is not working. I have checked Memory Data using Flash Magic It is same as in...
  • Ulink no tristate after flash
    Hello, I use the ulink for flash a XC164CM board. everything working fine. But now I like to use a pin (P3.7_/BRKIN) of the JTAG Interface for general purpose output. The problem is, the ULINK don...