• hard fault exception
    I am generating optimsed code using simulink coder for LMS filter using stm32f4VG407 discovery board,KEIL MDK-ARM, but upon single conversion of signal through ADC , it is stopping at hardfault handler...
  • fopen hard fault (__sys_open)
    Hello, I am using an STM32F437 MCU with Keil MDK-ARM V4.71a. My application (no RTOS) reads an SD Card on start up via the RL-ARM FFS. This has been working for a few years but I have now upgraded...
  • isr_evt_set make a hard fault
    when I use ARTX with liuminary's LM3S8962 in ISR if I use isr_evt_set, it run into hard fault,if not use the function,it run ok,i don't know why,can I get help? void key_int_isr( void ) __irq {...
  • CMSIS-FreeRTOS Hard Fault
    I downloaded the CMSIS-RTOS Blinky with STM32CubeMX (STM32F769I-Discovery) example from the Pack installer. After running with the initially configured RTX5 RTOS implementation I used the Manage...
  • Hard Fault exception
    Hello all, I'm using Atsam3s4a(cortex -m3) with keil Ide. I see my code gets locked in hard fault handler in Startup_sam3s.h (start up file generated by Ide). when i look into fault status registers...