• Cypress Cy3684 Mon51
    Dear Sirs I have exactly the same problem. Unable to connect uV3.3c to monitor. Could you please help with this? I use mon-int-sio1.hex, SIO1 Connector 38400 Baud. There is no step by...
  • Clock rate required for debugger on CY3684 EZ-USB
    I'm using a Cypress CY7C68013A on their CY3684/3674 EZ-USB Advanced Development Board. If I change the 8051's clock rate from 48MHz to either 24MHz or 12MHz the Keil debugger stops. I am trying to determine...
  • cypres fx2lp usb controler
    Hi im uaing the Cypress fx2pl usb controller. input to fx2lp is D+,D-,output is what formate please helpme
  • FX2LP Sourcing IN packets?
    Hello, This is a non-Keil specific question but since lots of folks familiar with the Fx2Lp seems to be hanging out here i'm hoping that someone might have an answer: I'm using EP2 as an input...
  • Firmware for EZ-USB FX2LP
    I am very new to this subject. I have a cypress developer board EZ-USB FX2LP. I just want to connect the board one side to the usb-port and other side the IDE port to HDD. When I plug the board to...