• USING FLASH MAGIC
    Hello, i have build a isp programmer for micro lpc i use the rs232 signal and flash magic for programming i would program the micro directly by keil it is possible this?
  • Flash and Code memory read
    Hi, I am trying to read the flash and code memory contents of my micorcontroller TI MSC1210Y5 (32kb flash) using the 6-pin JTAG connector through a programmer device (which is connected through ...
  • Flash magic on MCB2300
    Flash Magic version is 4.11. Jumpers J10: ON Jumpers J13: OFF Jumpers J4: OFF any a operation of the follows gets the same error of "operation failed. failed to autobaud-step1" click "ISP...
  • Flash Magic and P89C669
    Hi everyone, Does anyone has experience with the phyCORE 8xC51-Mx2 developmentboard + phyCORE controller module occupied with the P89C669 controller and the Flash Magic tool? The phyCORE controller...
  • Flash Magic and MCBx51
    I have a KEIL MCBx51 board with a P89C662 chip on it. I downloaded FlashMagic. I am trying to use it to FLASH a HEX file into the chip but I am unable to connect. Do I need to set the board or the chip...