• what is the use of default in switch-case?
    what is the use of default in switch-case?
  • What is the default segment in indirect addressing mode?
    I am reading the start_va.a66. I found some statements like following don't specifies segment value. Then what is the default segment value for the [R8+]? MOV R5,#0 MOV R2,[R8+] ; Count JMPR...
  • Locating segments in HDATA by default
    Okay, I think this should be an easy one! I have a program/data partition at 0x20000. I also have internal SRAM from 0-0x1300. Without the 'Use internal SRAM' box checked, I get this config: ...
  • Defaulting variables to HDATA
    Hello. This problem seems to have come up a few times in the past.. - http://www.keil.com/forum/docs/thread2857.asp - http://www.keil.com/forum/docs/thread3123.asp - http://www.keil.com/forum...
  • BL51 seems to default to NOINDIRECTCALL
    Using full version of uV v2.33 C51 v7.03 A51 v7.03 BL51 v5.02 None of the calls that are passed in to functions as callbacks are listed in the "INTRABANK CALL TABLE OF MODULE" section of the M51...