• Pullup Resistors
    I am writing a GPIO input object that reads the pinstate of GPIO port 0. I am putting in a feature where the different pull resistor states can be specified. They are done so with an enum type in the...
  • pullup resistor value for I2C
    Hai.... I have a problem while reading the eeprom. while reading it i got some garbage values which i was not stored in eeprom. i think it may be because of pullup resistor. Can anyone please...
  • Reg: keypad needs pullup resistors
    Whether ordinary 4x4 keypad requires pullup or pull down resistors to be connected in order to generate signals.
  • pull down resistor
    im using lpc1768 i connected button to P0.5, led to P0.4 initially the button pin should go low, if i press the button P0.5 should get high but the pin is always high i checked the pin with multimeter...
  • Avoid pull-down resistor
    How can I avoid pull-down resitors during reset and configure de C167CR manually? After reset the microcontroller I can see with the scope that data bus signal are not good, it falls down slowly and...