• "Insufficient ARARM debug information!" error message
    After installing mkd305 update, I can no longer open the Advanced RTX window under Peripherals during simulation. I was previously able to do so. I now get the error message "Insufficient ARARM debug...
  • "Insufficient RAM for Flash Algorithms ! Full Chip Erase Failed!"
    I am using LPC4357 board with Jlink. I want to erase the full chip but it throws the error "Insufficient RAM for Flash Algorithms ! Full Chip Erase Failed!"...what modifications do i need to perform...
  • debug information
    Hi, is it possible to print some debug information to the debug window (build output window)? Like printf() for the uart interface... best regards Bernd
  • show debug information
    Hello, I want to install printf("hallo welt %d\n", intvariable) in my code for debug information. Where can I see this information when I have no usart? Is there a command line in uvision where I...
  • Debug information with A51 and macros
    Is anybody try to debug assembler code with MPL macros. In the source window, line in file is not correct adress instructions. I sent 2 email to Keil about three weeks and I haven't any answer. Also...