• port in tristate mode
    Hi, I work on ST10F168 with 6M*16bits external ram. This external Ram is used by the microcontroller and a xilinx, so the datas and adress bus are divided by 2 chips. I would to know if i can put POL...
  • Programming external flash using ULink
    Is it possible to use the ULink to both program the XC16X Flash AND a flash chip attached to the XC16X. I get the impression it might be from the Option/debug setup but find the ULink rather under documented...
  • ULINK and XC161
    I'm not able to debug my XC161 (step-AB) board using ULINK ver1.1 (targhet not found). JTAG interface works with a lot of messages, but the debug session don't start. Is anybody out there actually using...
  • ULINK flashing error
    Good morning, I have a problem flashing program (example "Blinky" from Keil/ARM/Examples/ directory) into LPC2129 (on 12Mhz) via JTAG (ULINK) from uVision3 (WIN XP). Everything seems fine. When I click...
  • ULINK flashing Texas TMS
    Hi, i'm trying to flash the TMS470R1B1M Microcontroller with ULINK and the keil claims the following message : , i need to configure "Cannot Write to RAM for Flash Algorithms !". I've tried to change...