• What's the minimum time between samples on ADC of STR912F?
    Hi, I'm trying to sampling a sinusoidal wave with frequency of 60Khz, put the ADC tooks about 7us to do one conversion. (using fadc = 24Mhz, continuos mode and only one channel enabled). My question...
  • ARM: STR912 EV board
    Why can not running at 96Mhz ... I did set PLL 96mhz and FMI Clock = Rclock.. in start.s Assembly file.. R Clock is master clock 96mhz ST Datasheet writed FMI max 96mhz... I tested it start.s...
  • arm development and evaluation boards
    hi, i got lpc2378 arm development board,str912f evaluation board for arm968, embedded linux cross development for arm and atmel sam9263 development board. now my doubt, how to interface all these board...
  • Looking for ARM development board
    Hi friends, I am new to embedded .I am looking for some low costdevelopment board which can help me to get handson experience with ARM. is ther any low cost kit or some resources which can help me...
  • ARM board and OLED
    Hello! I am using LPC2138, i have interfaced the OSRAM OLED (128 x 64) with parallel data bus i.e not using i2c interface of data communication. the harware is OK. all the voltage levels are...